Specifications

7–98 CLI Commands
PORT_1_TOPOLOGY=FABRIC
PORT_2_TOPOLOGY=FABRIC
Used only in switch (FC-SW) topology.
Specifies switch topology for a host port.
PROMPT=“new prompt”
Specifies a 1- to 16-character prompt displayed when the controller’s CLI prompts for
input. Only printable ASCII characters and spaces are valid. The new prompt name
must be enclosed within quotes. When changed, the new text entered for this switch
takes effect immediately.
REMOTE_COPY = “controller name”
NOREMOTE_COPY
IMPORTANT: This command works in a remote copy environment only using
HSG80 ACS V8.4P code, where local (initiator) and remote (target) sites coexist.
Enables or disables remote copy at each site by naming the controller pair—called a
node—at each site. When the name is set on one controller in the pair, the other
controller automatically receives that same name, too. Once the name is set, remote
copy becomes enabled at that site.
The controller name must be a meaningful name up to 8 characters long.
NOTE: Do not use “local” and “remote” as node names. These are reserved as
keywords.
SCSI_VERSION=SCSI-2 (Default)
SCSI_VERSION=SCSI-3
Specifies the host protocol to use; requires operating system support. SCSI-3 is
limited SCSI-3, meaning that only OpenVMS operating systems use SCSI-3 mode in
multiple-bus failover mode. Once set,