Specifications

7–68 CLI Commands
PTL (SCSI-location)
Causes the device fault LED on the device at the given SCSI location to flash. See
“Mapping the Physical Devices with Device PTL Addressing,” page 3–6 for an
explanation of the PTL addressing naming format.
Not all devices have a device fault LED. Therefore, they do not appear to respond to
the LOCATE command.
UNITS
Causes the device fault LEDs of all devices used by the units to flash. This command
is useful to determine which devices are not currently configured into logical units.
Enter LOCATE CANCEL to turn off the device fault LEDs.
container-name
Causes the device fault LEDs on the devices within the container-name to flash. If a
device name is given, the device's fault LED is turned on. If a storageset name is
given, the fault LED on all of the devices assigned to the storageset turns on. Use
LOCATE CANCEL to turn off the LEDs.
unit-number
Causes the device fault LEDs on the devices making up the unit-number to flash. Use
LOCATE CANCEL to turn off the LEDs.
Examples
This example shows how to cause the device fault LED on device DISK10000 to
flash:
LOCATE DISK10000
LOCATE CANCEL