Specifications

7–21
Compaq HSG80 Array Controller ACS Version 8.4 Configuration and CLI Reference Guide
ADD REMOTE_COPY_SETS
IMPORTANT: This command works in a remote copy environment only using
HSG80 ACS V8.4P code, where local (initiator) and remote (target) sites coexist.
Creates a remote copy set (RCS) in multiple-bus failover that comprises one unit at
the initiator site and one unit at the target site. The units may be a single disk or part
of a storageset, mirrorset, or RAIDset. Up to 2 units may be assigned to each remote
copy set for a total of 8 copy sets.
Syntax
ADD REMOTE_COPY_SETS remote-copy-set-name initiator unit-name target
path-name
Parameters
remote-copy-set-name
The remote copy set name must start with RCS and may consist of a maximum of 9
characters including letters A through Z, numbers 0 through 9, periods (.), dashes (-),
or underscores (_).
IMPORTANT: It is common to name a remote copy set RCSn, where n is a
sequentially-assigned, unique identifier. This naming convention presents the
user with the type of container and its unique identifier.
Switches
initiator unit-name target path-name
Specifies the name of the controller pair—called a node—receiving the command.
The initiator unit name is the logical unit name specified with the ADD UNIT
command. The target path-name consists of two parts: 1) the controller pair name
specified with the SET controller REMOTE_COPY= command and 2) the remote
unit name, which you create. Both parts are separated with a back slash.