Specifications

6–22 Configuring Storagesets
To turn it off, use the following command:
SET THIS_CONTROLLER NOCOMMAND_CONSOLE_LUN
CAUTION: Disabling the CCL while SWCC is running may result in loss
of connection for the StorageWorks Command Console. Turn off SWCC
before issuing the command.
Finding the CCL Location
To see where each CCL is located, use the following commands:
SHOW THIS_CONTROLLER
or
SHOW OTHER_CONTROLLER
Look under host port to find the Command Console LUN location. Because the CCL
is not an actual device or unit, the SHOW UNITS command will display only unit
information and no CCL locations.
Multiple-Bus and Transparent Failover in
SCSI-2 and SCSI-3 Modes
The way the host sees the CCL varies, depending on whether you’ve enabled
transparent or multiple-bus failover modes and whether you are in SCSI-2 or SCSI-3
mode.
SCSI-2 Mode
In SCSI-2 mode, the CCL is located at the first unassigned LUN. As units are added,
it automatically floats—or moves—to the next available LUN.