Specifications

6–2 Configuring Storagesets
Configuring Storagesets with CLI Commands
One method of configuring storagesets is manual configuration. This method allows
you the most flexibility in defining and naming storagesets. See Chapter 7, “CLI
Commands.” for complete information about the CLI commands shown in this
chapter.
Unit Switches
You can enable the Unit switches listed in Table 6–1 for the listed storagesets and
devices.
See “ADD UNIT,” page 7–27 and “SET unit-number,” page 7–126 for a complete list
and further explanation of the unit switches.
Table 6–1 Unit Switches
Container Type
Switch
ENABLE_ACCESS_PATH DISABLE_ACCESS_PATH MAXIMUM_CACHED_ TRANSFER IDENTIFIER NOIDENTIFIER PREFERRED_PATH NOPREFERRED_PATH READ_CACHE NOREAD_CACHE READAHEAD_CACHE NOREADAHEAD_CACHE WRITE_PROTECT NOWRITE_PROTECT WRITEBACK_CACHE NOWRITEBACK_CACHE RUN NORUN
RAIDset
✔✔✔✔✔✔✔✔✔
Stripeset
✔✔✔✔✔✔✔✔✔
Mirrorset
✔✔✔✔✔✔✔✔✔
NoTransportable Disk
✔✔✔✔✔✔✔✔✔
Transportable Disk
✔✔✔✔✔✔✔ ✔