Specifications

5–17
Compaq HSG80 Array Controller ACS Version 8.4 Configuration and CLI Reference Guide
5. Connect the host bus cable between the switches and the host adapters.
IMPORTANT: Figure 5–4 shows two cables for a host connection. The cables
can go either to the same host or they can go to separate hosts.
6. Route and tie the cables as desired.
7. Turn on the subsystem.
Some operating systems may require you to start the host to see the devices
attached to the new controller. See the HSG80 Array Controller ACS Version 8.X
Release Notes for your operating system.
Using One Switch
For a detailed description of the controller and cables, see Chapter 1, “General
Description.”
Figure 5–5 shows how to connect dual-redundant controllers to the host using one
switch.