Specifications

5–14 Configuring an HSG80 Array Controller
11. Enter any other optional CLI commands for your configuration.
See “Optional Steps,” page 5–29 and Chapter 7, “CLI Commands.”
12. Display details about the controller you configured. Use the following command:
SHOW THIS_CONTROLLER FULL
See “SHOW,” page 7–133.
IMPORTANT: If you are using a PC or terminal with the maintenance port cable
during configuring and have not yet cabled the configuration, you must connect
the optical host bus cables in the desired configuration as shown in the next
section.
Connecting in Transparent Failover Mode to
the Hosts
You can connect dual-redundant controllers to your hosts with one or more switches.
Using Two Switches
For a detailed description of the controller and cables, see Chapter 1, “General
Description.”
Figure 5–4 shows how to connect dual-redundant controllers to the host using two
switches.