Specifications

5–4 Configuring an HSG80 Array Controller
Configuring and Cabling an HSG80 Array
Controller
You can use these procedures to configure and cable your controller in one of three
configurations:
■ “Configuring a Single Controller,” page 5–6
❏ “Connecting a Single Controller to the Host,” page 5–8
■ “Configuring in Transparent Failover Mode,” page 5–12
❏ “Connecting in Transparent Failover Mode to the Hosts,” page 5–14
■ “Configuring in Multiple-Bus Failover Mode,” page 5–20
❏ “Connecting in Multiple-Bus Failover Mode to the Hosts,” page 5–23
When configuring, you will use the CLI commands in Chapter 7, “CLI Commands.”