Specifications

5–2 Configuring an HSG80 Array Controller
Figure 5–1. Configuration Process
Single Controller
Transparent Failover Mode
Multiple-Bus Failover Mode
“Configuring a Single
Controller,” page 5–6
“Configuring in
Transparent Failover
Mode,” page 5–12
“Configuring in
Multiple-Bus Failover
Mode,” page 5–20
“Connecting a Single
Controller to the
Host,” page 5–8
“Connecting in Transparent
Failover Mode to the Hosts,”
page 5–14
“Connecting in Multiple-
Bus Failover Mode to the
Hosts,” page 5–23
“Configuring a Stripeset,” page 6–6
“Configuring a Mirrorset,” page 6–7
“Configuring a RAIDset,” page 6–8
“Configuring a Striped Mirrorset,” page 6–10
“Configuring a Single-Disk Unit,” page 6–12
“Partitioning a Storageset or Disk Drive,”
page 6–13
Continue creating
units until the
configuration is
complete.