Specifications

2–4 Compaq StorageWorks HSG80 Array Controller ACS Version 8.5 Maintenance and Service Guide

Use the following steps to establish a local connection for setting the controller initial

configuration:

1. Turn off the PC or terminal, and connect it to the controller, as shown in Figure 2–1.

a. For a PC connection, plug one end of the maintenance port cable into the terminal;

plug the other end into the controller maintenance port.

b. For a terminal connection, refer to Figure 2–1 for cabling information.

Figure 2–1. PC/terminal to maintenance port connection

CAUTION: The cables connecting the controller and the PC (or terminal) might cause

radio and television interference. Only connect a PC or terminal to the controller via

the maintenance port when communication with the controller is necessary.

2. Turn on the PC or terminal.

Maintenance port

cable for a PC

Maintenance port

Optional Maintenance

Port Cable for a

Terminal Connection

BC16E-xx cable

assembly

Ferrite bead

RJ-11 adapter

RJ-11 extension

cable

PC serial port

adapter, 9-pin

D-sub to 25-pin

D-sub

CXO6572B

1 2 3 4 5 6