Specifications

5–86 Compaq StorageWorks HSG80 Array Controller ACS Version 8.5 Maintenance and Service Guide

83020100 An unsupported message type or terminal request was received by the CONFIG virtual

terminal code from the CLI.

83030100 Not all alter_device requests from the CONFIG utility completed within the timeout interval. 01

84010100 An unsupported message type or terminal request was received by the CLONE virtual

terminal code from the CLI.

85010100 HSUTIL tried to release a facility that wasn’t reserved by HSUTIL. 01

85020100 HSUTIL tried to change the unit state from MAINTENANCE_MODE to NORMAL but was

rejected because of insufficient resources.

85030100 HSUTIL tried to change the usb unit state from MAINTENANCE_MODE to NORMAL but HSUTIL

never received notification of a successful state change.

85040100 HSUTIL tried to switch the unit state from MAINTENANCE_MODE to NORMAL but was not

successful.

86000020 Controller was forced to restart in order for new code load or patch to take effect. 00

86010010 The controller code load function is about to update the program card. This requires

controller activity to cease. This code is used to inform the other controller this controller will

stop responding to inter-controller communications during card update. An automatic restart

of the controller at the end of the program card update will cause normal controller activity to

resume.

86020011 The EMU firmware returned a bad status when told to prepare for a code load.

■ Last Failure Parameter [0] contains the value of the bad status.

8A040080 New cache module failed diagnostics. The controller has been reset to clear the error. 00

8A050080 Could not initialize new cache module. The controller has been reset to clear the error. 00

Table 5–18 Last Failure Codes (Sheet 40 of 41)

Code Description

Repair

Action

Code