Specifications

Event Reporting: Templates and Codes 5–85

64030104 A DD is already in use by an RCV DIAG command—cannot get two RCV_DIAGs without

sending the data for the first.

■ Last Failure Parameter [0] contains DD_PTR.

■ Last Failure Parameter [1] contains blocking HTB_PTR.

■ Last Failure Parameter [2] contains HTB_PTR flags.

■ Last Failure Parameter [3] contains this HTB_PTR.

64040100 An attempt to allocate a free VAR failed. 01

80010100 An HTB was not available to issue an I/O when it should have been. 01

80030100 DILX tried to release a facility that wasn’t reserved by DILX. 01

80040100 DILX tried to change the unit state from MAINTENANCE_MODE to NORMAL but was rejected

because of insufficient resources.

80050100 DILX tried to change the usb unit state from MAINTENANCE_MODE to NORMAL but DILX

never received notification of a successful state change.

80060100 DILX tried to switch the unit state from MAINTENANCE_MODE to NORMAL but was not

successful.

80070100 DILX aborted all cmds via va$d_abort( ) but the HTBS haven’t been returned. 01

80090100 DILX received an end msg which corresponds to an op code not supported by DILX. 01

800A0100 DILX was not able to restart his timer. 01

800B0100 DILX tried to issue an I/O for an opcode not supported. 01

800C0100 DILX tried to issue a oneshot I/O for an opcode not supported. 01

800D0100 A DILX device control block contains an unsupported unit_state. 01

800F0100 A DILX cmd completed with a sense key that DILX does not support. 01

80100100 DILX could not compare buffers because no memory was available from

EXEC$ALLOCATE_MEM_ZEROED.

80110100 While DILX was deallocating his deferred error buffers, at least one could not be found. 01

80120100 DILX expected an Event Information Packet (EIP) to be on the receive EIP queue but no EIPs

were there.

80130100 DILX was asked to fill a data buffer with an unsupported data pattern. 01

80140100 DILX could not process an unsupported answer in dx$reuse_params( ). 01

80150100 A deferred error was received with an unsupported template. 01

Table 5–18 Last Failure Codes (Sheet 39 of 41)

Code Description

Repair

Action

Code