Specifications
Event Reporting: Templates and Codes 5–79
12070102 vsi_ptr->allocated_this not set.
■ Last Failure Parameter [0] contains the ASSUME instance address.
■ Last Failure Parameter [1] contains nv_index value.
01
12080102 vsi_ptr->cs_interlocked not set.
■ Last Failure Parameter [0] contains the ASSUME instance address.
■ Last Failure Parameter [1] contains nv_index value.
01
12090102 Unhandled switch case.
■ Last Failure Parameter [0] contains the ASSUME instance address.
■ Last Failure Parameter [1] contains nv_index value.
01
120A0103 WARP expand point value does not match blocks.
■ Last Failure Parameter [0] contains the warp address.
■ Last Failure Parameter [1] contains the warp expand point value.
■ Last Failure Parameter [2] contains the warp blocks value.
01
120B2380 Forced restart of the controller upon a cache battery failure. This is only done when under
conditions which require the restart for error recovery.
23
120C0101 Found invalid UPS Descriptor state.
■ Last Failure Parameter[0] contains UPS Descriptor state.
01
120D0100 Initialization code was unable to allocate enough memory to set up the send data descriptors
for local buffer transfers.
01
20010100 The action for work on the CLI queue should be CLI_CONNECT, CLI_COMMAND_IN or
CLI_PROMPT. If it isn’t one of these three, this bugcheck will result.
01
20020100 The FAO returned a non-successful response. This will only happen if a bad format is
detected or the formatted string overflows the output buffer.
01
20030100 The type of work received on the CLI work queue wasn’t of type CLI. 01
20060100 A work item of an unknown type was placed on the CLI’s SCSI Virtual Terminal thread’s work
queue by the CLI.
01
20080000
20090010
200A0000
This controller requested this controller to
restart
.
Applies to
shutdown
.
Applies to
selftest
.
00
200B0100 Could not get enough memory for FCBs to receive information from the other controller. 01
Table 5–18 Last Failure Codes (Sheet 33 of 41)
Code Description
Repair
Action
Code