Specifications

Event Reporting: Templates and Codes 5–71

04170102 The template value found in the esd is not supported by the Fault Manager. The bad template

value was discovered while trying to translate an esd into an eip.

■ Last Failure Parameter [0] contains the instance code value.

■ Last Failure Parameter [1] contains the template code value.

04180103 The COMMON$MEM_FAIL_TEMPLATE template found in the esd is not supported by the Fault

Manager. The bad template was discovered while trying to translate an esd into an eip.

■ Last Failure Parameter [0] contains the instance code value.

■ Last Failure Parameter [1] contains the template code value.

■ Last Failure Parameter [2] contains the template flags value.

04190100 A NULL pointer was found for the target_ctx, or the target_ctx has an invalid type. 01

05010100 In recursive_nonconflict could not get enough memory for scanning the keyword tables for

configuration name conflicts.

06010100 The DUART was unable to allocate enough memory to establish a connection to the CLI. 01

06020100 A port other than terminal port A was referred to by a set terminal characteristics command.

This is illegal.

06030100 A DUP question or default question message type was passed to the DUART driver, but the

pointer to the input area to receive the response to the question was NULL.

06040100 Attempted to detach unattached maintenance terminal. 01

06050100 Attempted output to unattached maintenance terminal. 01

06060100 Attempted input from output only maintenance terminal service. 01

06070100 The DUART was unable to allocate enough memory for its input buffers 01

06080000 Controller was forced to restart due to entry of a CNTRL-K character on the maintenance

terminal.

07010100 All available slots in the FOC notify table are filled. 01

07020100 FOC$CANCEL_NOTIFY( ) was called to disable notification for a rtn that did not have

notification enabled.

07030100 Unable to start the Failover Control Timer before main loop. 01

07040100 Unable to restart the Failover Control Timer. 01

07050100 Unable to allocate flush buffer. 01

07060100 Unable to allocate active receive fcb. 01

Table 5–18 Last Failure Codes (Sheet 25 of 41)

Code Description

Repair

Action

Code