Specifications

Event Reporting: Templates and Codes 5–67

034B0100 Insufficient memory available for DS init buffer allocation. 01

034C0100 Insufficient memory available for static structure allocation. 01

034D0100 DS init DWDs exhausted. 01

034E2080 Diagnostics report all device ports are broken. 20

034F0100 Insufficient memory available for reselect target block allocation. 01

03500100 Insufficient memory available for command disk allocation. 01

03520100 A failure resulted when an attempt was made to allocate a DWD for use by DS CDI. 01

03530102 A DWD with an illegal address has been found.

■ Last Failure Parameter [0] contains the bad DWD pointer.

■ Last Failure Parameter [1] contains the corresponding PCB pointer.

035A0100 Invalid SCSI message byte passed to DS. 01

035B0100 Insufficient DWD resources available for SCSI message passthrough. 01

03640100 Processing run_switch disabled for LOGDISK associated with the other controller. 01

03650100 Processing pub unblock for LOGDISK associated with the other controller. 01

03660100

03670100

No memory available to allocate pub to tell the other controller of

reset

to one if its LUNs.

Applies to

a BDR

036F0101 Either send_sdtr or send_wdtr flag set in a non-miscellaneous DWD.

■ Last Failure Parameter [0] contains the invalid command class type.

03780181 In ds_get_resume_addr, the buffer address is non-longword aligned for FX access.

■ Last Failure Parameter [0] contains the re-entry dbd address value.

Table 5–18 Last Failure Codes (Sheet 21 of 41)

Code Description

Repair

Action

Code