Specifications

Event Reporting: Templates and Codes 5–61

02F60103 An invalid modification to the no_interlock VSI flag was attempted.

■ Last Failure Parameter [0] contains the nv_index of the config on which the problem was

found.

■ Last Failure Parameter [1] contains modification flag.

■ Last Failure Parameter [2] contains the current value of the no_interlock flag.

If the modification flag is 1, then an attempt was being made to set the no_interlock flag, and

the no_interlock flag was not clear at the time. If the modification flag is 0, then an attempt

was being made to clear the no_interlock flag, and the no_interlock flag was not set (== 1)

at the time.

02F70100 During boot testing, one or more device ports (SCSI) were found to be bad. Due to a problem

in the SYMBIOS 770 chip, the diagnostic may occasionally fail the port even though the

hardware is OKAY. A reboot should clear up the problem. If the port is actually broken, logic to

detect a loop that repeatedly causes the same bugcheck will cause a halt.

02F80103 An attempt was made to bring a unit online when the cache manager says that a member

CLD was not in the appropriate state.

■ Last Failure Parameter [0] contains the nv_index of the config on which the problem was

found.

■ Last Failure Parameter [1] contains the map type of that config.

■ Last Failure Parameter [2] contains the value from CACHE$CHECK_CID that was not

acceptable.

02F90100 A call to EXEC$ALLOCATE_MEM_ZEROED failed to return memory when allocating structures

for read ahead caching.

02FA0100 A read ahead caching data structure (RADD) is inconsistent. 01

02FB2084 A processor interrupt was generated by the controller’s XOR engine (FX), indicating an

unrecoverable error condition.

■ Last Failure Parameter [0] contains the FX Control and Status Register (CSR).

■ Last Failure Parameter [1] contains the FX DMA Indirect List Pointer register (DILP).

■ Last Failure Parameter [2] contains the FX DMA Page Address register (DADDR).

■ Last Failure Parameter [3] contains the FX DMA Command and control register (DCMD).

02FC0180 The FX detected a compare error for data that was identical. This error has always previously

occurred due to a hardware problem.

Table 5–18 Last Failure Codes (Sheet 15 of 41)

Code Description

Repair

Action

Code