Specifications

5–48 Compaq StorageWorks HSG80 Array Controller ACS Version 8.5 Maintenance and Service Guide

01090105 An NMI occurred during EXEC$BUGCHECK processing.

■ Last Failure Parameter[0] contains the executive flags value.

■ Last Failure Parameter[1] contains the RIP from the NMI stack.

■ Last Failure Parameter[2] contains the read diagnostic register 0 value.

■ Last Failure Parameter[3] contains the FX Chip CSR value.

■ Last Failure Parameter[4] contains the SIP last failure code value

010D0110 The System Information structure within the System Information Page has been reset to

default settings. The only known cause for this event is an I960 processor hang caused by a

reference to a memory region that is not implemented. When such a hang occurs, controller

modules equipped with inactivity watchdog timer circuitry will spontaneously reboot after the

watchdog timer expires (within seconds of the hang). Controller modules not so equipped will

just hang as indicated by the green LED on the OCP remaining in a steady state.

010E0110 All structures contained in the System Information Page (SIP) and the Last Failure entries

have been reset to their default settings. This is a normal occurrence for the first boot

following manufacture of the controller module and during the transition from one software

version to another if and only if the format of the SIP is different between the two versions. If

this event is reported at any other time, follow the recommended repair action associated

with this Last Failure code.

010F0110 All structures contained in the System Information Page and the Last Failure entries have

been reset to their default settings as the result of certain controller manufacturing

configuration activities. If this event is reported at any other time, follow the recommended

repair action associated with this Last Failure code.

01100100 Non-maskable interrupt entered but no Non-maskable interrupt pending. This is typically

caused by an indirect call to address 0.

01110106 A bugcheck occurred during EXEC$BUGCHECK processing.

■ Last Failure Parameter [0] contains the executive flags value.

■ Last Failure Parameter [1] contains the RIP from the bugcheck call stack.

■ Last Failure Parameter [2] contains the first SIP last failure parameter value.

■ Last Failure Parameter [3] contains the second SIP last failure parameter value.

■ Last Failure Parameter [4] contains the SIP last failure code value.

■ Last Failure Parameter [5] contains the EXEC$BUGCHECK call last failure code value.

Table 5–18 Last Failure Codes (Sheet 2 of 41)

Code Description

Repair

Action

Code