Specifications

Event Reporting: Templates and Codes 5–47

Repair Action

The Repair Action code at byte offset 105 indicates the recommended repair action code

assigned to the failure. This value is used during Symptom-Directed Diagnosis procedures

to determine what notification/recovery action should be taken. For details about

recommended repair action codes, see the “Recommended Repair Action Codes” section

on page 5–88.

Error Number

The Error Number is located at byte offset 106. Combining this number with the

Component ID field value uniquely-identifies the reported failure.

Component ID

The component ID is located at byte offset 107. This number uniquely-identifies the

software component that detected the failure. For details about components ID numbers,

see the “Component Identifier Codes” on page 5–93.

Table 5–18 contains the numerous last failure codes, in ascending order, that might be

issued by the controller.

Table 5–18 Last Failure Codes (Sheet 1 of 41)

Code Description

Repair

Action

Code

01000100 Memory allocation failure during executive initialization. 01

01010100 An interrupt without any handler was triggered. 01

01020100 Entry on timer queue was not of type AQ or BQ. 01

01030100 Memory allocation for a facility lock failed. 01

01040100 Memory initialization called with invalid memory type. 01

01082004 The core diagnostics reported a fault.

■ Last Failure Parameter[0] contains the error code value (same as blinking OCP LEDs

error code).

■ Last Failure Parameter[1] contains the address of the fault.

■ Last Failure Parameter[2] contains the actual data value.

■ Last Failure Parameter[3] contains the expected data value.