Specifications

Event Reporting: Templates and Codes 5–37
03D8450A During device initialization, the device reported the SCSI Sense Key ILLEGAL
REQUEST. Indicates that there was an illegal parameter in the command
descriptor block or in the additional parameters supplied as data for some
commands (FORMAT UNIT, SEARCH DATA, etc.). If the target detects an
invalid parameter in the command descriptor block, then it shall terminate
the command without altering the medium. If the target detects an invalid
parameter in the additional parameters supplied as data, then the target
may have already altered the medium. This sense key may also indicate that
an invalid IDENTIFY message was received.
41 45
03D9450A During device initialization, the device reported the SCSI Sense Key UNIT
ATTENTION. This indicates that the removable medium may have been
changed or the target has been reset.
41 45
03DA450A During device initialization, the device reported the SCSI Sense Key DATA
PROTECT. This indicates that a command that reads or writes the medium
was attempted on a block that is protected from this operation. The read or
write operation is not performed.
41 45
03DB450A During device initialization, the device reported the SCSI Sense Key BLANK
CHECK. This indicates that a write-once device encountered blank medium
or format-defined end-of-data indication while reading or a write-once
device encountered a non-blank medium while writing.
41 45
03DC450A During device initialization, the device reported a SCSI Vendor Specific
Sense Key. This sense key is available for reporting vendor specific
conditions.
41 45
03DD450A During device initialization, the device reported the SCSI Sense Key COPY
ABORTED. This indicates a COPY, COMPARE, or COPY AND VERIFY command
was aborted due to an error condition on the source device, the destination
device, or both.
41 45
03DE450A During device initialization, the device reported the SCSI Sense Key
ABORTED COMMAND. This indicates the target aborted the command. The
initiator may be able to recover by trying the command again.
41 45
03DF450A During device initialization, the device reported the SCSI Sense Key EQUAL.
This indicates a SEARCH DATA command has satisfied an equal comparison.
41 45
Table 5–15 Instance Codes (Sheet 16 of 24)
Instance
Code
Description Template
Repair
Action
Code