Specifications

Troubleshooting Resources 4–23
■●❍●●❍●
2D All master cabinet SCSI buses are not set
to ID 0.
Set PVA ID to 0 for the cabinet with the
controllers. If problem persists, try the
following repair actions:
1. Replace the PVA module.
2. Replace the EMU.
3. Remove all devices.
4. Replace the cabinet.
■●❍●●●❍
2E Multiple cabinets have the same SCSI ID.
More than one cabinet have the same
SCSI ID .
Reconfigure PVA ID to uniquely-identify
each cabinet in the subsystem. The
cabinet with the controllers must be set to
PVA ID 0; additional cabinets must use
PVA IDs 2 and 3. If error continues after
PVA settings are unique, replace each
PVA module one at a time. Check cabinet
if problem remains.
■●❍●●●●
2F Memory module has illegal DIMM
configuration.
Verify that DIMMs are installed correctly.
■●●❍❍❍❍
30 An unexpected bugcheck occurred before
subsystem initialization completed.
An unexpected Last Failure occurred
during initialization.
Reinsert controller. If that does not correct
the problem, reset the controller. If the
error persists, try resetting the controller
again, and replace it if no change occurs.
■●●❍❍❍●
31 ILF$INIT unable to allocate memory.
Attempt to allocate memory by ILF$INIT
failed.
Replace controller.
■●●❍❍●❍
32 Code load program card write failure.
Attempt to update program card failed.
Replace program card.
■●●❍❍●●
33 NVPM structure revision too low.
NVPM structure revision number is less
than the one that can be handled by the
software version attempting to be
executed.
Verify that the program card contains the
latest software version. If the error
persists, replace controller.
Table 4–5 Solid OCP Patterns (Sheet 3 of 5)
Pattern OCP
Code
Error Repair Action