Specifications

MSM800XEV/XEL / Connectors & Jumpers

www.kontron.com 30

5.1.3 X1 Power Supply

Pin Signal Pin Signal

1 GND 2 VCCSUS +5Volt Input Supply

3 NC 4 (+12V input)

5 NC 6 Main_SW (Push button to switch on the board if J2 is open)

7 GND 8 VCCSUS +5Volt Input Supply

VCCSUS = 5Volt Main Supply Input

Pin placement:

5.1.4 X10 VGA Monitor (CRT-signals)

X10 Header 15 pins HiDensity DSUB

10 Pin -M Signal Pin Signal

2 VGA red 1 Red

4 VGA green 2 Green

6 VGA blue 3 Blue

8 Horizontal Synch 13 H-Synch

9 Vertical Synch 14 V-Synch

5 + 11 Bridged

1 Ground 5, 6, 7, 8 Ground

3 NC

5 NC

7 Serial_Data 12 DDC-SDA

10 Serial_Clock 15 DDC-SCL

The VGA-CRT signals from X10 must be wired to a standard VGA HiDensity DSub connector (female):

The LCD signals must be wired panel specific.

Solder-side view of the female 15pin HiDSub