Specifications

Maintenance & Service Guide 4–7
Removal & Replacement Procedures
4.7 Hood Sensor
1. Prepare the workstation for disassembly (Section 4.2), then place it on its side.
Ä
CAUTION: Before removing the access panel, ensure that the workstation is turned off,
and all cables are disconnected from the back of the workstation.
2. Remove the access panel (Section 4.5).
3. Unplug the cable from the system board 1.
4. Slide the sensor toward the front side of the workstation 2.
5. Remove the sensor from the chassis 3.
To replace the hood sensor, reverse the above procedure.