System information

Pointing Devices and Keyboard
Hardware Guide 3–15
Enabling the Numeric Keypad at Startup
By default the notebook starts up with the numeric keypad
disabled. You can set the notebook to start up with the numeric
keypad enabled. The numeric keypad can be enabled or disabled
with
Fn+num lk in either startup state.
To set the notebook to start up with the numeric keypad enabled:
1. Turn on or restart the notebook. Press F10 while the
F10 = ROM Based Setup message is displayed in the lower
left corner of the screen.
❏ To change the language, press F2.
❏
For navigation instructions, press F1.
2. Select Advanced > Device Options, then press enter.
3. Toggle on the Num Lock State at the Boot field,
then press
F10.
4. To save your preference and exit Computer Setup, select
File > Save Changes and Exit, then follow the instructions
on the screen.
To disable the numeric keypad at startup, repeat the above
procedure, toggling off the Num Lock State at the Boot field.
279360-002.book Page 15 Friday, December 13, 2002 2:11 PM