Personal Computer Maintenance & Service Guide
Table Of Contents
- NOTICE
- CONTENTS
- ABOUT THIS GUIDE
- PRODUCT DESCRIPTION
- SPARE PARTS
- REMOVAL AND REPLACEMENT PRELIMINARIES
- REMOVAL AND REPLACEMENT PROCEDURES
- 4.1 Disassembly Sequence Chart
- 4.2 Disassembly Preparation
- 4.3 Feet Installation
- 4.4 Logo Plate
- 4.5 Cable Lock
- 4.6 Access Panel
- 4.7 Front Bezel
- 4.8 Power Button
- 4.9 Subpanel and Bezel Blanks
- 4.10 Power Switch
- 4.11 Mass Storage Devices
- 4.12 Removing the Drivelocks
- 4.13 Expansion Boards
- 4.14 Board Guide
- 4.15 System Memory
- 4.16 AGP Graphics Board (440BX)
- 4.17 Processor Components
- 4.18 System Board
- 4.19 Internal Speaker
- 4.20 Lithium Battery
- 4.21 Fan Assembly
- 4.22 Power Supply
- 4.23 Converting a Desktop to a Minitower
- 4.24 Converting a Minitower to a Desktop
- CONNECTORS, JUMPERS, AND SWITCHES
- SPECIFICATIONS
- SERVICE NOTES
- INDEX
Compaq Deskpro EP Series of Personal Computers 4-23
10. Press in on the tabs to release the vertical drivelock from the chassis, then lift it up and
out of the system while at the same time rotating the drivelock slightly to clear the
travel slots at the bottom of the drivelock.
11. Remove the spring from the post (see inset).
Removing the Vertical Drivelock
To reinstall the vertical drivelock, reverse the previous procedure.
To reinstall the horizontal drivelock:
1. Insert the left side of the drivelock (with the rounded tabs) into the slots on the drive
cage.
2. Place the washer on the middle tab on the underside of the drivelock.
3. Compress the spring, then lower the drivelock onto the drive cage until it snaps into
place.
Reinstalling the Drivelocks