Installation guide

Installing on OpenVMS Alpha
4.3 Post-Installation
Rev. 1/9/01–A
Web-Based Enterprise Service Installation Guide 4–11
RCM installed. To collect data, type SET DEFAULT RCM$DATA and then
@RCM$DIR:RCM_START
Release notes are available in SYS$HELP:RCM*.RELEASE_NOTES.
WEBES has been installed to the location specified.
If you chose to remove WEBES, the Compaq Analyze and CCAT tools will be
removed automatically. To add or remove a tool you will need to do a
PRODUCT REMOVE WEBES and then reinstall, selecting the tools you want to
keep.
4.3 Post-Installation
Be aware of the following post-installation procedures.
4.3.1 Cluster Environments
Note
Make note of the node you install from—the base install node. You usually run any
post-install cluster command procedures from the base install node, and always run
all uninstall commands from the base install node.
Depending upon the configuration of your cluster you have several options for installing the
WEBES kit. The kit is set up so that nodes that can see a common installation directory can
share that installation.
For nodes that share a system disk, the installation point is normally sys$common:[compaq].
All of the nodes that can see this directory can be set up to share the installation by entering the
following command after installing the kit:
$ @svctools_home:[bin]cluster setup
This command copies all of the node specific files into a directory for each node that can see
the installation. For nodes that cannot see the installation, nothing is changed.
For example, look at the sample cluster configuration in Figure 4–1. Sys Disk is a shared
system disk for Node A and B. Com Disk is a shared common disk between nodes A, B, and
C. (Node C has its own system disk that is not shown.)