Installation guide

Installing on OpenVMS Alpha
4.2 Installing WEBES
Rev. 1/9/01–A
Web-Based Enterprise Service Installation Guide 4–9
Phase Mode File
------------ ------ ---------------------------------
LPMAIN DIRECT RCM$STARTUP.COM
LPMAIN DIRECT RCM_SYSMAN_STARTUP_MGDSYS.COM
Scheduling next collection at: 1-NOV-2000 03:20:00.00
%RUN-S-PROC_ID, identification of created process is 202001D0
To collect RCM data now, use @RCM$DIR:RCM_START -now
Note that you can modify the .CFG file to change any value if you are not satisfied with the
default values.
4.2.2 Installing Compaq Analyze
Messages similar to the following appear during the Compaq Analyze installation phase of
WEBES.
1. Enter Y or N to have the WEBES director process started and stopped as part of your
system’s automatic procedures:
Do you want to add DESTA$STARTUP and DESTA$SHUTDOWN to system startup and
shutdown procedures? [YES]
2. Enter or confirm your service obligation information. If this is a new system with the
standard warranty, the obligation number is the same as the serial number, and the start
date is the current date:
WEBES Service Obligation Validation
-----------------------------------
Please input service provider name [Provider]:
Please input system/subsystem serial number [A01234567890]:
Is the Service Obligation number the same as the serial number [y]:
Please enter the start date of the current obligation [20-Sep-2000]:
3. Confirm your entries:
Service Provider: Provider
System/subsystem serial number: A01234567890
Service obligation number: A01234567890
Service obligation start date: 20-Sep-2000
Is this information correct [y]:
The install will now finish configuring WEBES for your system. This could
take a little while depending upon your system.
The install is now configuring CA for this system.
ConfigDefaultsCAOpenVMS.txt will be enrolled by Director.
4.2.3 Installing CCAT
Messages similar to the following appear during the CCAT installation phase of WEBES.