Installation guide

Installing on Tru64 UNIX
3.4 Uninstalling WEBES
Rev. 1/9/01–A
Web-Based Enterprise Service Installation Guide 3–17
# /usr/sbin/webes_delete
The following options appear:
You may choose one of the following options to deinstall:
1) Compaq Analyze < version >
2) Compaq Crash Analysis Tools <
version >
3) UniCensus < version >
4) ALL of the above
5) Redisplay menus
6) Continue without deinstalling any products
Enter your choices or press RETURN to redisplay menus.
Choices(forexample,124-5):1
2. Type the number of the tool that you wish to uninstall. (In the above example, Compaq
Analyze is uninstalled but CCAT, UniCensus, and the WCC remain installed.)
3. The installation kit displays a Yes-or-No confirmation prompt. Type Ye s to remove the
selected tool.
3.4.2 Uninstalling All WEBES Tools
Note
If you previously used the WEBES kit to install a component (Compaq Analyze,
CCAT, or UniCensus) and you then perform the setld -d WEBESBASE<version>
command, you may get the following message:
setld: WEBESBASE<version>: not currently installed, cannot delete
If you get this message and you wish to delete a WEBES component from a
standalone system, use the /usr/sbin/webes_delete script to remove that component.
To uninstall all WEBES tools from your Compaq Tru64 UNIX system, perform the following
tasks.
If you installed WEBES in a TruCluster environment, you always must uninstall all of
WEBES using setld -d and then reinstall. You cannot uninstall individual WEBES tools with
the /usr/sbin/webes_delete script described in Section 3.4.1, Uninstalling Individual WEBES
Tools.
To isolate individual tools, uninstall all of WEBES using setld -d and then reinstall, selecting
the tools you want to keep.
1. Enter the following command:
# setld -d WEBESBASE310
Standalone systems display messages similar to the following: