Installation guide

Installing on Tru64 UNIX
3.2 Installing WEBES
Rev. 1/9/01–A
3–12 Web-Based Enterprise Service Installation Guide
Do you want to change any of these parameters?
[ yes/no ] [ q,?,o ](default= no):
Do you wish to enable RCM to make a collection every time this machine
reboots?
[ yes/no ] [ q,?,o ](default= no):
Saving the options you have just entered to file. Please wait.
Configuration options saved in rcm_config file.....
Customer details saved in rcm_customer_info file.....
System details saved in rcm_ssnum file.....
RCM UniCensus installation proceeds after all settings have been entered and confirmed.
**************** UniCensus Setup is complete ****************
UniCensus options can be changed at any time by running unisetup again.
To run UniCensus the following options are recommended:
default /var/opt/UniCensus/unicensus -all
RCM output /var/opt/UniCensus/unicensus -config
See the overview notes for full detail on execution options.
All systems proceed with messages similar to the following. Clusters will show multiple
messages:
Configuring "UniCensus for Alpha AXP Digital UNIX - < version >"
(UNICEN<
version >)
3.2.3 Installing CCAT
The following appears while installing the CCAT phase of WEBES.
Installing Compaq Crash Analysis Tool
We will install rules only for this operating system <
version > unless you
choose otherwise.
Remove all non <
version > knowledge rule (KRS) files? [yes/no] [q,?]
(default= yes):
Enter Y or N for whether to remove the rules.
Compaq Crash Analysis Tool (CCAT) < version > has been sucessfully loaded.
3.2.4 Finishing the WEBES Installation
The following appears while finishing the WEBES installation.