Technical data

Troubleshooting
4-20
Problem Possible Cause Action
Computer does not boot
from an internal SCSI hard
disk drive.
Computer not configured for
SCSI hard disk drive operation.
Run the BIOS Setup utility and set the IDE
controller option to “Disabled.” This
disables the onboard IDE interface.
Note:
If you have both IDE and SCSI
hard disk drives installed, the computer
uses the IDE hard disk drive as the boot
device.
Operating system software is
not installed on the SCSI hard
disk drive.
Install the appropriate operating system.
Requested partition does not
exist.
Partition the SCSI hard disk drive and then
reload the operating software.
Loose cable connectors. Secure all cable connections.
SCSI adapter has failed. Replace the SCSI adapter.
SCSI ribbon cable has failed. Replace the ribbon cable.
SCSI hard disk drive has failed. Replace the SCSI hard disk drive.
continued