Technical data

Parts Replacement
5-68
Removing the Control Panel Assembly and Cable (Short Tower
Computer)
1. Turn off the computer, monitor, and then disconnect power from the
computer.
2. Remove the outside cover.
3. Remove front bezel.
4. Push in on the tabs to disengage the control panel assembly.
5. Disconnect the cables from the control panel assembly noting the following
when you reconnect.
−
White and black is the reset switch.
−
White, black, and red is the power switch.
−
Red and black is hard disk drive activity LED.
−
Yellow and black is the power LED. It is on top of the hard disk
drive indicator.
6. Slide the cables through the slots.
The cables and their attached switch or indicators are now inside the
computer.
7. Unplug the cable connection from the backplane.
8. Rotate the speaker to remove it from the option card assembly.
9. Remove the control panel assembly cables from the computer.