Technical data

Beyond Quick Setup

1-15

Attaching the Hasp (Low Profile Computers)

To attach the hasp:

1. Pull the hasp out from the clip at the rear edge of the cover and turn it

around 180 degrees so the hasp is pointing out to the rear of the computer.

2. Insert the cover clip adjacent to the slot in the rear panel into the slots in the

rib of the hasp.

3. Slide the hasp toward you and seat the rib atop the hasp securely to the

outside cover.

4. Replace the outside cover, carefully sliding the hasp tab through the slot in

the rear panel.

5. Connect the power cord to your computer and to a wall outlet.

6. Turn on your computer and then turn on all external devices.

DEC0117

Figure 1-7. Attaching the Hasp (Low Profile Computers)