Technical data

Technical Specifications
A-10
Main Logic Board Switch Settings
The switch settings located on the main logic board can be set to control many
features in your computer. Use the following tables and figure to locate the switch
settings on the main logic board and then modify the settings for desired results.
Feature Function Setting Description
Clear password Clear
Normal
(1)
SW1-1, ON
SW1-1, OFF
(1)
If you forget your password, via BIOS Setup,
set this switch to ON and then restart the
computer.
Recovery mode Recovery
Normal
(1)
SW1-2, ON
SW1-2, OFF
(1)
If your flash BIOS upgrade failed and the BIOS
is corrupted, set this switch to ON so you can
boot your computer from a Crisis Recovery
diskette. Refer to the README.TXT provided
with the flash BIOS upgrade.
Clear CMOS Clear
Normal
(1)
SW1-3, ON
SW1-3, OFF
(1)
Clears CMOS of all BIOS setup information.
Use the Clear setting when your computer will
not boot, and BIOS setup cannot be accessed
due to configuration data corruption. This
switch must be set back to Normal before
rebooting your computer.
Factory setting Reserved SW1-4, ON
SW1-4, OFF
(1)
Reserved for future use.
FLASH ROM
write
Enable
Disable
(1)
SW1-5, ON
SW1-5, OFF
(1)
When disabled, prevents reprogramming of
BIOS.
Manufacturing
switch
For mfg.
Normal
SW1-6, ON
SW1-6, OFF
(1)
For use in manufacturing tests. Switch must
be set to OFF for PC normal functionality.