Installation guide

Chapter 6. Using Secure Path Manager
EK-WNTMP-MH. D01 123995-002 6-15
6.12 Adding New Storagesets with Secure Path
To add new storagesets to a Secure Path configuration, proceed as follows:
1. Use StorageWorks Command Console (SWCC) or CLI to create a new storageset/s
on the RAID Array.
2. Use CLI to assign a preferred path to the new unit, as described in Section 4.4.2.
3. Use appropriate procedures to add a new volume to the NT server or cluster.
4. Restart the host server(s) so that Windows NT and the Secure Path software can
configure the new unit.
6.13 Removing a Storageset with Secure Path
1. Use Windows NT Disk Administrator to delete the partition from the drive to be
removed using appropriate procedures.
2. Shutdown Windows NT on the host server(s).
3. Use StorageWorks Command Console (SWCC) or CLI to delete the storageset/s on
the RAID Array.
4. Reboot the host server(s) to allow the Secure Path software to configure storage
devices.