Installation guide

Chapter 6. Using Secure Path Manager
EK-WNTMP-MH. D01 123995-002 6-5
6.4 Path and Drive Status Monitor
The Secure Path Manager screen appears as shown in Figure 6 -6. The two paths
(Controller A and Controller B) are displayed green by the Manager when both paths
(host adapters, cabling and controllers), are functioning normally. The Manager keeps
track of the primary path (bus assignment) for each disk in the RAID subsystem. When
operating normally, the Manager displays each disk on the primary path to which it has
been assigned, as a disk icon, shaded yellow and gray. If a drive letter has been assigned
to the disk, it will be displayed above the disk icon.
Figure 6–5 Typical Secure Path Manager Display
Determining Disk Identity
Drives configured in a Secure Path environment may be identified three ways. If you
hover the cursor over a disk icon, The Manager will display the various identities of a
drive – port/bus/target/lun and disk #. You may also view this information by right-
clicking the mouse on the disk icon to launch the properties dialog for the drive.