Installation guide

StorageWorks Secure Path for Windows NT

4–2 123995–002 EK–WNTMP–MH. D01

4.2.2 Installing the Secure Path Driver and Agent

The following section describes how to install the Secure Path drivers and configuration

management agent on the host server.

1. Insert the StorageWorks Secure Path Software (v2.2) for WNT distribution CD in your

CD-ROM driver.

2. If you have CD AUTORUN enabled on your server, the Secure Path setup program

will start automatically. Otherwise, Choose “Run” from the START menu and enter

the command shown below, substituting your CD-ROM’s drive letter for the one

shown.

Drive_Letter:\SPINSTAL \SETUP.EXE

When the setup starts, choose the server install option. The server option will install

the drivers and the agent required by Secure Path.

Be prepared to designate those clients that you wish to allow to manage the host.

These names have to be fully qualified, for example “myserver.mydomain.com”.

There are many ways to configure TCP/IP on your network. They include a) host

files on servers and clients and b) DNS, with NetBios using DNS resolution. Check

with your system administrator to assure proper network configuration.

3. Make sure to enter a validation password. For cluster configurations make sure the

password is the same for each member of the cluster.

4.2.3 Installing the Secure Path Manager

The following section describes how to install the Secure Path management application

on the management station. The management application can be installed on the host

server, or on a separate management station.