Troubleshooting guide

1902 - 01 Drive not installed.
1902 - 02 Cartridge not installed.
1902 - 03 Tape motion error.
1902 - 04 Drive busy error.
1902 - 05 Track seek error.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
1902 - 06 Tape write protected error. The following codes apply to
error codes 1900 - xx through
1902 - 09 Unable to format. 1991 - xx:
1902 - 10 Format mode error. 1. Replace the tape cartridge
and retest.
1902 - 11 Drive recalibration error. 2. Replace the tape drive
expansion unit and retest.
1902 - 12 Tape not servo written. 3. Replace the system board
and retest.
1902 - 13 Tape not formatted.
1902 - 21 Got servo pulses second time
but not first.
1902 - 22 Never got to end of tape
after servo check.
1902 - 27 Drive not compatible with
controller.
1902 - 28 Format gap error.
1903 - xx Tape Drive Sensor Test
1903 - 01 Drive not installed.
1903 - 23 Change line unset.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
1903 - 27 Drive not compatible with The following codes apply to
controller. error codes 1900 - xx through
1991 - xx:
1904 - xx Tape Beginning of Tape/End
of Tape Test 1. Replace the tape cartridge
and retest.
1904 - 01 Drive not installed. 2. Replace the tape drive
expansion unit and retest.
1904 - 02 Cartridge not installed. 3. Replace the system board
and retest.
1904 - 03 Tape motion error.