Specifications

10. If Enclosure B contains a fixed disk drive, disconnect the fixed disk
drive LED connector from the front of the enclosure and remove this
enclosure from the system chassis (Figure 7.11-5).
NOTE: If Enclosure B is a fixed disk drive replacement for a COMPAQ Portable
or COMPAQ PLUS Personal Computer, it may be necessary to remove the face
plate/LED assembly that is attached to the chassis. To do this, remove the
hex nut at the bottom of the face plate/LED assembly before removing
Enclosure B.
To replace Enclosure B, reverse Steps 1 through 10.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
CAUTION
When removing the enclosure, do not bend the drive ground strap located on the
top front shock mount of each enclosure.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Mass Storage Device Enclosure A Removal and Replacement
To remove Enclosure A:
1. Complete the removal procedures for all installed controller and expansion
boards (see Section 7.9).
2. Remove the mass storage device access plate (see Section 7.11).
3. Disconnect the power cables from the mass storage device(s).