Specifications

Computers) on the system board. (Figure 7.9-7).
NOTE: Controller and expansion board retaining screws may be located either
inside or outside the chassis.
To replace the diskette/tape controller board, reverse Steps 1 through 5.
NOTE: Ensure that the retainers on the bottom side of the board slots access
plate fit securely onto each board installed in the computer. Also be sure
that the board is in the board guide on the left.
Expansion Board Removal and Replacement
To remove COMPAQ memory expansion boards or any other expansion boards
installed in the computer:
1. Complete the Board Slots Access Plate Removal procedure (see Section 7.4).
2. Remove any signal cables attached to the board.
3. Remove the retaining screw that secures the board to the system chassis.
4. Gently pull the particular expansion board up and out of its socket on the
system board. Remove the board from the computer. (Figure 7.9-8).