Specifications

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
CAUTION
Pull only on the connector, do not pry. Pulling on the wires damages the
cable.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
4. Gently pull the video display controller board up and out of its socket
(J102 on COMPAQ PORTABLE 286 Personal Computers; J104 on COMPAQ Portable
and COMPAQ PLUS Personal Computers) on the system board and out of the
computer (Figure 7.9-5).
To replace the video display controller board, reverse Steps 1 through 4.
NOTE: Be sure that the board is in the board guide on the left.
Diskette/Tape Controller Board Removal and Replacement
To remove the diskette/tape controller board:
1. Complete the Board Slots Access Plate Removal procedure (see Section 7.4).
2. Disconnect the fixed disk drive controller board signal cables, if
installed (Figure 7.9-2).