Specifications

1716 - 51 Failed file I/O test The following steps apply to error
in read test codes 1700 - xx through 1716 - 59:
1716 - 52 Failed file I/O test in 1. Check the fixed disk drive
compare test controller board for the
proper switch setting
1716 - 53 Failed drive/head register (see Chapter 8). *
test 2. Replace the fixed disk drive
signal and power cables.
1716 - 54 Failed digital input 3. Replace the fixed disk drive
register test controller board. *
4. Replace the fixed disk drive
1716 - 55 Cylinder 1 failed assembly.
5. Replace the system board.
1716 - 56 Controller RAM failed
* 286 based COMPAQ Personal
1716 - 57 Controller to drive test Computers only
failed
1716 - 58 Failed to write sector
buffer
1716 - 59 Failed to read sector
buffer
1716 - 60 Non COMPAQ fixed disk
drive controller ROM
------------------------------------------------------------------------------
Error Error Required
Code Description Action
------------------------------------------------------------------------------
Tape Drive
19yy - xx
------------------------------------------------------------------------------
1901 - xx * Tape servo write The following steps apply to all
19yy - xx error codes:
1902 - xx * Tape format
1. Replace the tape cartridge.
1903 - xx * Tape drive sensor test 2. Replace the signal cable.
3. Replace the diskette/tape
1904 - xx * Tape BOT/EOT test controller board.
4. Replace the tape drive
1905 - xx * Tape read test assembly.
1906 - xx * Tape write/read/compare * 286 based COMPAQ Personal
test Computers only
1906 - 01 Drive not installed
1906 - 02 Cartridge not installed
1906 - 03 Tape motion error
1906 - 04 Drive busy error
1906 - 05 Track seek error
1906 - 06 Tape write protected error