Specifications

1716 - 02 Exceeded maximum hard error 3. Replace the fixed disk drive
limit controller board. *
4. Replace the fixed disk drive
1716 - 03 Previously exceeded maximum assembly.
soft error limit 5. Replace the system board.
1716 - 04 Previously exceeded maximum * 286 based COMPAQ Personal
hard error limit Computers only
1716 - 05 Failed to reset controller
1716 - 06 Fatal error while reading
1716 - 07 Fatal error while writing
1716 - 08 Failed compare of write/
read/compare test
------------------------------------------------------------------------------
Error Error Required
Code Description Action
------------------------------------------------------------------------------
Fixed Disk Drive
17yy - xx
------------------------------------------------------------------------------
1716 - 09 Failed to format a track The following steps apply to error
codes 1700 - xx through 1716 - 59:
1716 - 10 Failed sector wrap test
1. Check the fixed disk drive
1716 - 40 Failed cylinder 0 controller board for the
proper switch setting
1716 - 41 Drive not ready (see Chapter 8). *
2. Replace the fixed disk drive
1716 - 42 Recalibrate failed fixed signal and power cables.
disk drive 3. Replace the fixed disk drive
controller board. *
1716 - 43 Failed to format bad track 4. Replace the fixed disk drive
assembly.
1716 - 44 Failed fixed disk drive 5. Replace the system board.
controller diagnostics
* 286 based COMPAQ Personal
1716 - 45 Failed to get drive Computers only
parameters from ROM
1716 - 46 Invalid drive parameters
found in ROM
1716 - 47 Failed to park heads
1716 - 48 Failed to move disk table to
RAM
1716 - 50 Failed file I/O test in
write test
------------------------------------------------------------------------------
Error Error Required
Code Description Action
------------------------------------------------------------------------------
Fixed Disk Drive
17yy - xx
------------------------------------------------------------------------------