User`s manual

Dropouts
Dropouts are characters that are partially printed.
••A single sheet of paper may be defective. Try reprinting the job.
••Try adjusting the print density through your software or printer driver.
••The moisture content of the paper may be inconsistent, or the paper may
have moist or wet spots on the surface. Try paper from a fresh ream or
a different paper manufacturer. See Appendix B for paper specifications.
••The paper may have been damaged by inconsistent manufacturing
processes. Try paper from a different source.
Half of the Page Is Blank or Loss of Detail
The bottom of the page is blank, or part of a graphics image is cut off. This
may mean that your page is too complex for the standard printer memory:
••Set resolution to 300 dpi through your software or printer driver.
••You may need to install additional memory. See Appendix D for memory
installation instructions.
••Check your printer driver help screens for suggestions specific to your
driver’s settings.
Curled or Wrinkled Sheets
Media is curled or wrinkled when using the Paper Output Bin.
••Use the Front Output Slot by pushing the Paper Path Lever to the lower
position. This provides the straightest paper path. See “Selecting the
Paper Path” in Chapter 4.
••Use Paper Input Support located behind the Paper Input Tray. See
“Loading the Paper Input Bin” in Chapter 4.
6-12 Troubleshooting and Problem Solving EN