Setup guide

21
Figure 4 Avid Meridien Digital Media Board Set Connection
To install the digital media board set:
1. Turn off the Avid system and remove the power cord.
2. Put on an antistatic wrist strap and connect it to a metal ground
point on your system.
c
To avoid static damage to your circuit board, take the proper
antistatic precautions before handling the board. Often a wrist strap
is provided with upgrade kits.
3. Remove the cover, TARGA 2000 board set, and AGP board
according to the manufacturer’s documentation, if not already
done.
4. Install the digital media board set included in your kit (see Tab le 2
or Ta bl e 3).
5. Secure the digital media board set to the system.
n
Use any expansion slot blank panels you remove to cover any open slots not
used.
Connector under
this location
Standoffs (1 of 4)
Cable to edit display controller
0474101A.fm Page 21 Thursday, December 14, 2000 4:25 PM