Service manual

3-6 Service Manual
3.3 Running Diagnostics: the Test Command
The test command allows you to run diagnostics on the entire system,
an I/O subsystem, a single module, a group of devices, or a single
device.
Example 3–3 Sample Test Commands
P00>>> test # Tests the entire system.
# Default run time is 10 minutes.
P00>>> t pci0 –t 60 # Tests all devices associated
# with the PCI0 subsystem. Test
# run time is 60 seconds.
P00>>> test ms* # Tests all ms7cc memory modules.
P00>>> t –q # Status messages will not be
# displayed during test time.