Service manual

Removal and Replacement Procedures 5-9
In this example, the primary processor is in slot 0 and a secondary processor is
being replaced in slot 1.
1.
If you are replacing a secondary processor, remove the module from the
system. See Section 5.1.4.
2.
Power up the system and make note of the version of console firmware in
the processor modules. See
➋ in Example 5-3.
3.
Power down the system and remove all processor modules. See Section
5.1.4.
4.
Insert the new processor module. See Section 5.1.4.
5.
Power up the system and determine the version of console firmware in the
replacement module. If it is different from the other modules, boot LFU and
update the firmware using the update command. See ➎.
Continued on next page