Service manual

Removal and Replacement Procedures 5-7
6.
Build the EEPROM. See ➏.
7.
Power down the system, replace the other processor modules (see Section
5.1.4), and power up the system.
8.
Copy the EEPROM environment variables from a secondary processor to the
new primary processor. To do this, set a different module as primary and
copy the environment variables using the build –c command. See ➑.
9.
Set processor 0 as the primary processor. Then enter into the EEPROM the
8-digit LARS number and a short message (68 characters maximum) stating
the date and reason for service. See
➒.
10.
Boot the operating system.