Installation guide

Configuration
Rules
2-23
On GS140 systems you may install a floppy drive off of the floppy drive port on
the connector module of the KFE72-DA (in front panel slot 2 of the PCI card
cage), as shown in Figure 2–13.
If you only have one floppy drive on your GS140 system, and wish to move it
between partitions, see Section 2.10.
To include floppy drives on your GS60E system, you need a KFE72-LA adapter
for each partition for which you wish to add floppy support. (The KFE72-LA
would replace the KFE72-DA in the secondary partition.)
You can only use one floppy drive at a time when running utilities such as RCU,
even if you have two on your system. If you have two floppy drives installed on
either a GS140 or GS60E system and wish to use one, you must first remove
power from the DWLPB to which the other floppy is connected. Unplug the 48V
power input cable to the DWLPB, next to the hose connection on the DWLPB.
(See Figure 2–14 for the location for a DWLPB on a GS140; the orientation for
the GS60E would be as shown in Figure 2–14, rotated 90° to the right). Note
that both DWLPBs can be connected while you are running the operating sys-
tem.