Installation guide

iv
Chapter 4 Setting Up, Initializing, and Booting Logical
Partitions
4.1 Primary Console: Check Configuration 4-2
4.2 Step 1: Create and Initialize Environment Variables from the
Primary Console 4-6
4.3 Step 2: Initialize Partitions from the Primary Console;
Boot/Install OS in Partition 0 4-8
4.4 Step 3: Set and Initialize Environment Variables,
Boot/Install from Secondary Consoles 4-10
Chapter 5 Tips and Troubleshooting
5.1 Setting auto_action Within Partitions 5-2
5.2 How to Stop a Hung Secondary Partition 5-4
5.2 Halting All Partitions to Reconfigure 5-6
5.3 Correcting Errors in Environment Variables 5-8
5.4 Using Tools to Debug a Partition 5-10
Index
Examples
4-1 Check Configuration from Primary Console 4-2
4-2 Initial Commands from the Primary Console 4-6
4-3 Initializing the Partitions 4-8
4-4 Using the Secondary Consoles 4-10
5-1 Halting a Hung OS Instance in Partition 0 5-4
5-2 Halting a Hung OS Instance in Secondary Partitions 5-4
5-3 All Consoles: Shut Down Operating System 5-6
5-4 Primary Console: Disable Partitions and Reset EVs 5-6
5-5 Correcting a Bad Bit Mask 5-8