Installation guide

Configuration
Rules
2-19
On GS60E systems, the connection for the primary console terminal is located at
the rear of the system, above the AC power input box on the left side. On
GS140 systems, the connection for the primary console terminal is on the con-
trol panel of the GS140. You may also have a KFE70 or KFE72-EA adapter
connected to the TLSB in slot 8 to provide floppy support on the GS140, or a
KFE72-LA adapter to provide floppy support on the GS60E. This is optional,
however.
On both the GS60E and GS140, you must also have one KFE72-DA adapter for
each secondary partition, installed in a separate DWLPB PCI card cage. The
KFE72-DA adapter consists of three modules installed in slots 0, 1, and 2 of the
PCI card cage. See the KFE72 Installation Guide (EK-KFE72-IN) for instruc-
tions on how to install all variants of KFE72 adapters.
The console terminals for secondary partitions on the GS140 and the GS60E are
connected to the COM1 port of each KFE72 adapter, in slot 1 of the PCI card
cage, as shown in Figure 2–10.
The primary and secondary console devices can be character-cell video termi-
nals or serial line connections to another system or terminal concentrator. Sup-
ported graphics devices can be used by the operating system’s windowing soft-
ware on any partition.