Installation guide

Configuration
Rules
2-17
Each AlphaServer GS60E system comes with one DWLPB PCI card cage. The
I/O hose for this PCI must be connected to the I/O module in TLSB slot 8.
An additional DWLPB PCI card cage must be installed in the system for the
secondary partition. This DWLPB holds the KFE72-DA adapter needed for the
additional serial console terminal for the secondary partition.
Figure 2–9 shows two DWLPBs, one with a KFE72-DA adapter. The DWLPB
for the primary partition must be connected to the I/O module in slot 8 of the
TLSB bus, as shown. The other DWLPB, with a KFE72-DA for a secondary
partition, may be connected to any hose on another I/O module assigned to the
partition. See Figure 2–8 for hose numbers for the various I/O slots.
The DWLPA/DWLPB PCI PIU Installation Guide tells how to install DWLPB
PCI card cages.